Vase Mode Modular Drawers

prusaprinters

<p>These are modular drawers inspired by Dan O'Connell's (on a similar website) Modular Drawers 2.0.<br/> They print in vase mode (a drawer prints about 80 minutes, and the shell about 120).<br/> The shells can be interlocked on any side either flush or offset (3/4, 1/2, or 1/4 way apart).</p> <p><strong><em>EDIT</em></strong><br/> Some people had issues with the shell printing into two separate parts. This seems to happen when the width of the extruded material is smaller than half the thickness of the model wall. Possible solutions are higher flow rates or scaling down the entire model 5% or so. The general idea is to make the inner and outer lines just barely overlap.</p> <h3>Print instructions</h3><p>The G code was sliced in 0.35 layer height and in vase mode for the mk2. I have since upgraded my printer to an mk2.5 and have printed these files on my printer with same results so it shouldn't matter much.<br/> I did print the shells with a small brim but it'd probably be fine without one.</p>