Vase Mode Hex Corrugated Large Phone Holder W/Charging Slot!

prusaprinters

<p>This is my go-to phone holder. I have one in my office holding my work phone [iPhoneXR w/ OtterBox Commuter case pictured] as well as another on the dining table. It's great being able to comfortably see the phone in portrait mode while it's charging too!</p><p>Each holder prints in about 2.5 hours for me using only 20g of filament.</p><p>This model is designed for 0.4mm nozzle diameter prints. This is because the model has both an <i>inner </i>and <i>outer </i>vase “surface” with a gap that narrows to 0.5mm to allow the two “surfaces” to fuse for structural rigidity. The two “surfaces” are accomplished via a 0.1mm seam that runs the width of the stand and ends up purposely fusing during the print because the gap is so small.</p><ul><li>PLA</li><li><strong>vase mode</strong> / spiralized outer contour</li><li><strong>0.4mm nozzle</strong></li><li>0.2mm layer height</li><li>1mm base layer</li><li>no supports</li></ul><p>&nbsp;</p>