Vase #302

thingiverse

Print in vase mode or spiralize outer contour. Or, uncheck vase mode, set top layers to 0 and infill to 0%. Bottom layers set to 3 or more. Set walls to 2 or more for a more sturdy vase. Can be scaled to fit your needs. But I found out that scaling above 104% will put some infill in the little fins, and take from 2.5 hours to print to 4.5 hours. Photo shows 110mm tall, 54mm wide. It has not been tested for being water proof. If you make it, please post a photo. I'd like to see your print! Enjoy...