Variable Chihiros A Plus LED aquarium stand

thingiverse

I formerly built a stand that functioned well, but it added too much height and was inflexible when it came to adjusting the angle at which light hits the surface. This simple gravity-holding stand uses a straightforward design, where the inside is pressed against the lamp, while the foot secures it in place. Two feet are included: one larger and one smaller. Two of the insides can hold the lamp at a relatively consistent angle, and adding a single foot provides sufficient stability. Print the inside and the larger foot flat, but print the small foot upright. As for now, I'm developing a 10mm wide version that seems compact despite being functional. Update 20191028: I've added v3, which allows you to print both parts. In this version, the inside should not detach itself from the lamp.