Vanquish VS4-10 Pro Roll Bar

pinshape

I've crafted a Roll Bar to fit the Vanquish VS4-10 Pro Half Cab Body, It is an easy installation that requires some drilling. The 2 base plates come with 2 x 2.5mm holes pre-drilled in them, These are the holes the roll bar attaches to, but first used to align the plates and drill the necessary holes, You need to remove the 3 screws from each side of the shell that hold the interior piece in place, I then used the middle screw to temporarily attach the printed plate so it was held securely, then you need to drill the remaining 2 x 2.5mm holes for the mounting screws (I used some countersunk screws and a countersink tool to give a clean appearance), fit the 2 screws in the holes you just drilled to mount the plate and remove the first temporary screw. Next, you need to drill the 2 holes (the ones that were already in the plates) that mount the actual roll bar to the plate using a 3mm drill bit. To attach the roll bar, first attach the roll bar to the side bars using 2 M3 x 12mm screws, Then simply mount the roll bar to the shell using 2 M3 x 12mm screws for the front mount and 2 M3 x 10mm screws for the rear mounts.