Valve Index Controller grip extension AND Bumper

thingiverse

Liked the idea of the grip extention and the bumber but couldn't add them independently, so why not smash them together! https://www.thingiverse.com/thing:4286427 - Grip https://www.thingiverse.com/thing:4035295 - Bumper Printed 0% infill with 3 outer layers. Needs a little coaxing to fit with the ring going on last. A hot air gun can help for a final adjustment if required. The orientation used makes for a nice outer finish but inside needs work to clean up so as not to damage the controller. This is also why I used a 'Wet Wipe' tissue stuck as a lining using 'spray on glue'. Decided not to remove the button hole but might do so yet. This also means (I found out later) that there is an area with minimal adhesion due to layer density with orientation near the first hole cut out from grip. So you might want to tip it over a bit more flat at top. For fun I used a heat sensitive filament you can just see in picture. Looks better after a real work out.