Valentine goblet(te)

prusaprinters

Two versions of this design are shown; the first “Heart” is a PIP with no support featuring a small heat on a pedestal rising in the center of the goblet. the second in two parts - the goblet with a small wedge -shaped well in the center to accept the separate “open heart” piece.I successfully printed these in both PLA and PETG (gcode provided for PLA) at 0.2 layer height and no support with the following exceptions; 1) the open heart is printed at 0.1 and support everywhere and the goblets were sliced with variable height for the last .5 mm (with ironing) for a smooth lip.The open heart did require some finishing. carefully removing the support and then using a diamond file and 600 grit sandpaper to clean up rough areas.One other note: I think the “heart” version would be a lovely way to present a ring to your sweetheart.