v8 gasoline engine

cults3d

Educational v8 engine model, it is designed so that it can simulate the main rotation movements of a real one. All the pieces have a certain sizing tolerance so that they can fit and rotate freely, even so it is recommended to use solid Vaseline on the rolling surfaces that you consider necessary. The approximate measurements of the motor without counting the base are: 28.8cm long, 21.2cm wide and 19.2cm high. Unless parts are scaled, a printer with a minimum print volume of 30x20x20 cm is required. And the use of supports is necessary. 2 assembly tools are included to facilitate the correct alignment of the crankshaft parts. In turn, it is recommended that the crankshaft parts be glued. Print list: assembly tool 1 assembly tool 2 2 unit Base side A Base side B Block 2 unit Cap bushing Connecting rod bolt 8 unit Connecting rod cap 8 unit Connecting rod 8 unit Crank 2 Crank bushing Crankshaft adjusting bolt 8 unit Crankshaft journal 4 unit Long shaft crankshaft Piston 8 unit Shaft (crankshaft) 3 unit Shaftless crankshaft 6 unit Short shaft crankshaft Other parts: M3x30mm screw with nut 16 unit M3x35mm screw with nut M4x20mm screw with nut 8 unit Superglue NOTE: As not all printers are the same it is likely that some screw holes will need to be reworked with a drill bit. This model cannot be commercialized and is for personal use only.