v400/superacer removable bltouch probe.

thingiverse

Alternative probe as a replacement or potentially higher accuracy avoiding pressing the joints / pei to hard altering measurements. Note unexpected results are likely to occur using "modified "klipper or klipperscreen variants" eg zoffset on modified klipper screen isn't testz. This would lead to a crash. Probe_calibrate from terminal would need to be used. WARNING with any probe change always run probe_calibrate then delta_calibrate to apply new offset. List of settings to change. For further safety it horizontal_move_z: should probably be set to 100-75mm this is the height it stops at before it goes to probe. eg a lower to 30mm above the bed with a 31mm long probe or unknown 'zoffset" would = a crash. Last remarks fluidd/mainsail offset buttons are not "testz" this will not apply a real offset. please refer to https://www.klipper3d.org/Bed_Level.html#the-paper-test . [delta_calibrate] horizontal_move_z: 58 Speed: 100 Note pins use the endstops on the nano mini 2.0 apposed to the dedicated pins due to unexpected behavior [bltouch] pin_move_time: 0.680 probe_with_touch_mode: true sensor_pin: ^PA2 control_pin: PB2 x_offset: 0 y_offset: 0 z_offset: 60 pin_up_touch_mode_reports_triggered: false speed: 7 lift_speed: 20 stow_on_each_sample: false samples_tolerance: 0.0125 samples:2 sample_retract_dist: 2 samples_result:average samples_tolerance_retries: 15 [bed_mesh] speed: 150 horizontal_move_z: 58