V1 + V2 + V3 Diatone Tyrant 630 / 540 Gopro 3 holder (25 deg)

thingiverse

Mount for Diatone Tyrant 630, 540, and 530 with an angle of 25 degrees is a crucial upgrade. Version 1 was too bouncy and flexible, wasting time and filament. Upgrade to Version 2, which provides more GoPro contact surface and stability at almost the same weight. Version 3 features the same design as Version 2 but mounted with zipties (max 2x4mm), ensuring a secure fit. GoPro is safely positioned and out of danger with 5 and 6 inch props. The mount's mass is approximately 20g with support and 16g without support. Print in TPU or Ninjaflex with 30% infill and two perimeter walls. Use support material to ensure a strong structure. Print all fans at full power, as excessive air flow can cause issues. The recommended FFF profile is available for download. For CTC Bizer MK10 users, the following settings are optimal: General Settings: Retraction distance: 1.5mm (updated) Retraction speed: 25mm/s (updated) Nozzle diameter: 0.4mm Layer height: 0.15mm Solid top/bottom layer: 5 (updated) Perimeter walls: 2 Infill pattern: Full Honeycomb (updated) External fill pattern: Rectilinear Overlap: 11% Minimum infill length: 0.1mm Support Settings: Support infill: 17% Extra inflation distance: 1.6mm Dense support layer: 3 Dense infill percentage: 65% Horizontal offset: 0.2mm Temperature Settings: Table material: ABS Juice (thin film, avoid contact!) Extruder temperature: 230 degrees Table temperature: 0 degrees (room temperature/25 degrees) Fan Settings: All fans run at full power always, including the first layer. Speed Settings: General speed: 37mm/s (updated) Outline speed: 60% Infill speed: 100% Support speed: 80% X/Y axis movement speed: 150mm/s Z-axis movement speed: 22.5mm/s Other Settings: Extra inflation distance: 5 sq/mm Bridging speed/extrusion: 100% Allow single extrusion for internal and external infill Allowed perimeter overlap: 50% Minimum travel for retraction: 1.0mm