v-tail quadcopter 40 degree motor mount

thingiverse

This is a substitute rear motor mount for a v-tail using two 1/2 inch booms at the back. The frame is from batbones on flitetest.com, however it will also work with anycopter variants too. I printed it with 5 perimeters, 200 microns, 50% infill with PLA. It's probably best to use ABS though since it's less brittle, but it would just add another weak point that I can crash through to save the motors again someday :)\n\n \n \n Guidelines\nTo print the left and right side, simply copy and reverse \nPrint out and bevel off sharp edges and defects \nDrill out the hole in the boom \nFly securely