V-Slot Ramps Enclosure

thingiverse

I needed a case for my D-Bot build that could accommodate the full graphics card without any issues. The enclosure comes with three interchangeable tops, designed to fit different fan sizes. If the rail height isn't perfect for your project, you can easily adjust it in your preferred 3D software. As of May 2nd, 2017, I've included some ultra-thin fan grills (only 2 mm thick) that will keep stray wires away from the fans and occupy minimal space inside the enclosure. These grills are inspired by Parametric Fan Grille by jridley. On May 20th, 2017, I made significant changes to the end of the enclosure. The ramps were moved further into the case, allowing the terminal block to be housed within it now. This makes wiring much simpler. The original design is still available, but the updated version is listed as v2. The display case shown in the image can be found here: Full Graphics Display Case. Print Settings: Printer Brand: Prusa Printer Model: Prusa Clone Rafts: No Supports: Yes Infill: It's not crucial, I used 20% and it turned out fine.