V-Minion Z_Cap modified with a M8 reverse bowden

prusaprinters

Needed a reverse bowden setup for my Ratrig V-Minion....Didn't find one online that would use the M8 fitting that was removed from the Dragonfly BMO in the Full Kit….The M8 threads were a little tight…..I needed to chase the threads with a tap to make it so I could screw the fitting in by handI ran out of Prusament ASA Orange, so I made this test piece out of Prusament ASA Jet BlackMay add models for M10 and M6 fittings if needed8-15-22 **** added three more .stl's……. two of the .stls are parts with looser fitting threaded holes and a test part .stl with three threaded holes labeled 0 1 2….. 0 = original part, 1 = plus 1 part, and 2 = plus 2 part***** Print the Test Block and check the thread fit of the three test threads and choose the one that fits the best and print the model associated with the best fitting thread***For anyone interested in using a the M8 reverse bowden setup that's not incorporated into the Ratrig Z_cap, I made a part that is movable and a stand alone part…LINK BELOW***https://www.printables.com/model/166872-30_series_reverse_bowden_m8_threads