V-Core 3 Bistable Enclosure Lift

prusaprinters

This is a bistable enclosure lift mechanism for the RatRig V-Core 3. It keeps the lid closed when you close it and keeps it open when you open it.This lever arm mechanism changes the mechanical advantage provided to the gas struts as the lid goes from closed to open. This means that as the lid is opened the gas strut applies more force to the lid. This mechanism is bistable and keeps the lid up when you open it and keeps it down when you close it. The mechanism also allows the lid to open wider than the normal strut mounts would allow while using less of the strut’s travel range.This mechanism keeps the lid in the state that you leave it in but gives up a soft close in the process. As the lid is closed the weight is transferred off of the mechanism. If you don’t set the lid dow gently it will slam.ProsConsBistable: Stays how you leave itOpens wider than normal strut mountsLid does not shut gently on its ownPrintingInfill: 20%Necessary Parts and Hardware for each arm:Printable Parts1x HingeMountA1x HingeMountB2x SupportArmV3Hardware1x Gas Strut2x Gas Strut Mounting Brackets2x M4 3030 Drop In T-Nut2x M4 10mm2x M4 16mm2x M4 Nut4x M6 3030 Drop In T-Nut4x M6 12mm3x M6 25mmInstallation StepsIt is easiest to install when the lid is closed and the lid side panel are off. These steps help to make sure that each arm is supporting about half of the lids weight.Assemble the hinges and two arm parts with the 25mm M6 screws before attaching them to the framePosition the mechanism so that the lower arm is perpendicular to the rear post and the upper hinge is positioned as far back as possibleProp the lid open as wide as you want it to stay when openAttach the strut mounting brackets to the strut and attach the upper bracket to the armSet the lower bracket with the t-nuts into the 3030 of the lower frame but do not tighten itWith the lid propped open, lightly push the lower brackets toward the back of the machine so that the gas strut no longer has wiggle room and is engaged to the armTighten both lower brackets with this light pressure still in placeWhen you remove what is propping up the lid the lid should rest equally on both support armsFull Article Here: https://www.zebaker98.net/2022/05/08/V-Core-3-Bistable-Enclosure-Lift/