UV Curing Chamber

thingiverse

Here's an instructable I've created: https://www.instructables.com/id/UV-Curing-Chamber-for-Resin-Prints/ Video of the UV Chamber: https://youtu.be/PtdfpgYLTsM Finally finished my curing chamber after about a week, modeled and printed an enclosure for the electronics, and a bigger platter for the solar powered turntable because the one included was pretty tiny. Would have been shorter if I had more time. Made this to be able to cure everything that may come in contact with resin; gloves, paper towels, containers, tools, etc. Just trying to keep the waterways clean and properly dispose of things. Most parts I had on hand already, but I did have to buy a few things, most things you can get on AliExpress or Amazon if you don't want to wait, I've included the links below. The Amazon links are affiliated. I also printed the little housing for the LCD timer relay and SPST switch. The instructable has links to all the parts I bought. Here's what I would have done differently: Not use the 2-pin LED strip connectors, they're kinda bulky, I would just solder the strips with wire. Measure twice, cut once Take more time on making sure the vinyl had no bubbles Run the 12V power outlet in the back Use a stronger adhesive on the UV LEDs than what was provided Probably solder wires instead of using lever nuts Please note that UV lights can damage eyes and proper safety precautions and measures should be taken. I suggest wearing UV protection safety glasses while working with these lights.