USBasp dongle case

prusaprinters

<p>Case for the USBasp board (black) in two parts.</p> <p>The holes in the housing for the LEDs are sealed with transparent epoxy.</p> <p>The case is glued together and the programmer is inserted into the case.</p> <p>I also separated by cutting the conductive tracks from GND, and brought out the wires of the 5V - 3.3V switch jumper into two tracks (the cut points are marked with red lines).</p> <p>I made two types of wires, one has a jumper in the 10-pin connector - for 5V and a cable without a jumper for programming chips with a supply voltage of 3.3 volts</p> <h3>Print Settings</h3> <p><strong>Printer:</strong></p> <p>Ulti</p> <p class="detail-setting rafts"><strong>Rafts: </strong> <div><p>No</p></div> <p><strong>Supports:</strong></p> <p>No</p> <p class="detail-setting resolution"><strong>Resolution: </strong> <div><p>0,2</p></div> <p><strong>Infill:</strong></p> <p>20</p> <p><strong>Filament:</strong></p> my3d.art ABS <p>Grey</p> </p></p> Category: Tool Holders & Boxes