USB Type B wall mount

thingiverse

I created this USB type B holder because I wanted to expand my Arduino port onto the enclosure of my printer after I designed a casing for it, so I could print ABS better and make everything look as nice as possible from the outside. Feel free to use it for any projects you like, it has 4 mm holes and M4 nut holders for easy installation. After installing the connector, I covered it with hot glue but that's not necessary, my setup is permanent. You'll need a piece of 20x20 mm prototyping board, one USB Type B female PCB mount connector, and one USB Type B male cable with no connector on the end. I cut my cable that came with the printer, it was too short anyway. Alternatively, you can just buy one... https://de.aliexpress.com/store/product/Brand-New-High-Quality-USB-2-0-A-Male-to-USB-A-Female-Panel-Mount-Extension/1494743_32785594584.html USB Type B female connector - goo.gl/OH6yZO Print Settings: Printer: FlyingBear P902 Rafts: No Supports: Yes Infill: 100% Notes: You must print it upright (on the face where the connector comes out) and add a small support inside the case.