USB load resistor case
prusaprinters
<p>Case for this load resistor: <a href="https://nl.aliexpress.com/item/4000026696876.html">https://nl.aliexpress.com/item/4000026696876.html</a></p> <p>AliExpress calls it: "15W DC 3V-21V Electronic Test Load Resistor USB Interface Battery Discharge Capacity Tester with Adjustable Fan Current Module"</p> <p>Howto to get the board in the case:</p> <ol> <li>Remove the screws holding the fan on the heatsink.</li> <li>Remove the fan from the heatsink. The cable can remain connected.</li> <li>Slide the board into the case from the back</li> <li>Place the fan on the heatsink.</li> <li>Rotate the fans 90° counterclockwise.</li> <li>Take two screws that are about 3mm longer than the original screws. (Since the housing creates a gap between the heat sink and the fan, the original screws may not be sufficient.</li> </ol> Category: Electronics
With this file you will be able to print USB load resistor case with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on USB load resistor case.