USB Hub Hanger

thingiverse

I use a powered USB Hub for my Raspberry Pi and I began to utilize self-adhesive "hook & loop" material to secure it on a vertical portion of my desk/bench. Apparently, due to the Florida heat and humidity, the adhesive persistently failed to hold the Velcro-like tape in place. Frustrated by this outcome, I devised an innovative design solution. This design consists of three distinct pieces because I lacked confidence in my bridging capabilities to print it as a single piece. The dimensions of the hub measure 70mm x 70mm x 18mm, allowing it to fit a little loosely, but that is acceptable to me since I do not want to deal with it falling on the desk. The hub was printed in PLA solely because that was the material available in the printer at the time. Print Settings Printer: Geeetech Prusa i3 Pro C Acrylic Rafts: No Supports: No Infill: 20%