USB Drive Case

thingiverse

This is a custom USB Case designed specifically for 10 SanDisk Cruzer CZ36 drives. Although it may not be an exact fit, you can access the OnShape models at https://cad.onshape.com/documents/2aea3554550bab694129b55b/w/7b900a87fb43c4b512387a4f/e/cb26c09ced77ea259d1f3e90 to modify and use them freely. Sign up on OnShape.com, a fantastic 3D modeling software that's free. Each half of the case prints easily without any supports, but you can add a raft for a cleaner finish if desired. After printing, drill out the holes in the hinges to clean them up, then insert a metal rod through each one - it should fit snugly. You can also glue magnets into the 4 square holes if you prefer. To get rods and magnets, visit http://tinyurl.com/3mmRod and http://tinyurl.com/4mmCubeMagnet respectively. Enjoy your custom USB Case! Print Settings: Printer Brand: Printrbot Printer: Printrbot Plus Rafts: Doesn't Matter Supports: No Resolution: .2 Infill: 25% Notes: I found that rectilinear infill worked best, and preferred the zig-zag pattern through the walls between the USB slots over more perimeters. Honeycombs resulted in jerky prints and poor results, so I only used one shell.