USB C Charger mount and battery pad for the BoxyPixel DMG

thingiverse

This is a USB C charger mount and Battery pad for BoxyPixel's new DMG model. This fits any battery smaller than 115659. The tolerance for the battery support is tight. I start by holding the left side of the support above the battery compartment and push (twist the support) to push the charger port into the port opening. Once it clicks into the opening, I then set the rest of the support into the opening. To set the battery, connect the battery and push the excess wire down into the opening in the upper left corner and then push the wire towards the bottom (there is an opening for the excess under the support) once you have pushed down the excess and set the connection flat, you can sit the battery down into the compartment. Don't forget to add the two screws during assembly. You will need to lift the battery out of the way to place them. The 115659 is a 5,000mAh 3.7V Lipo Battery. Battery Link - https://smile.amazon.com/gp/product/B07BTSDPVQ/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1 I print this on an Ender 3 Pro and Cura slicer with a layer height of 0.16 (Dynamic) !!No supports!! !!No Build plate Adhesion!!(not needed)