USB-C 65W Charger compatible with Ryobi 18v

prusaprinters

NOTE: There is another version of this adapter, before you print this, check out…https://www.printables.com/model/615935-usb-c-65w-charger-compatible-with-dual-ryobi-18vThis printable adapter allows a single Ryobi 18v battery to power/charge your phone, laptop, or other USB-C / USB device.  Using a 4Ah or larger battery is suggested.Suggested print settings: - 0.20mm QUALITY - Prusament PETG (pictured using OVERTURE PETG Grass Green) - Infill density 20% - Infill pattern Cubic - 3 Perimeters - Supports requiredAssemble by printing…Qty. 1 of Ryobi18v to 65wUSBC Qty. 1 of Ryobi18v to 65wUSBC cap    …no glue required when also printing with a handle, simply sandwich this in between Qty. 1 of Ryobi18v to 65wUSBC handle     …requires Qty.4 of M4*12mm (0.7) cap head screw…or…Qty. 1 of Ryobi18v to 65wUSBC handle PP storage     …requires Qty.4 of M4*45mm (0.7) hex socket flat head cap screwSolder wires to the leaf spring battery contacts at about a 45deg. angle, see the 2nd to the last picture for wire lengths, allow all soldered connections to cool BEFORE inserting!!!  See the last picture for how the leaf spring battery contacts go in.Insert the 65W USB-C PD3.0 and 18W QC3.0 Multi Car USB Port 12V Socket Waterproof with Power Switch into the large hole, but do not push in all the way, leave it sticking out about 2cm so it's easier to attach wires to the back.Use pliers to push the Female Quick disconnects (that you already soldered onto the end of the wires) onto the USB-C socket (pay attention to the polarity!) then push the USB-C socket all the way in.Screw handle together manually/slowly to avoid melting the plastic.Here is the USB stick light seen in the pictures.Safety note: The PowerPole port is designed for 20 to 18V output from the battery pack, this can be used to run other loads.Caution: The PowerPole port can be used as an input (12 to 24V acceptable) to power just the USB-C charger by itself - BUT ONLY when NO BATTERY is plugged into the adapter.  Do NOT attempt to charge a battery in this adapter, charge in approved chargers.  The BMS built into all Ryobi 18v batteries will provide a safe low voltage cut-off.  Use of this adapter is safe when these instructions are followed, but any use is done at your own risk.  Do NOT leave batteries unattended, in direct sunlight, or anywhere near your campfire/cooking stove/open flame, space-heater, or water. Don't have a 3D printer yet? That's OK, order already printed from…https://jpelectron.etsy.com