USB Buck Converter Case Remixed

thingiverse

I remixed the design to better suit my requirements; the converters I bought are Amazon ASIN B01HXU1C6U, listed as "HiLetgo 5pcs DC-DC Buck Step Down Module 6-24V 12V/24V to 5V 3A USB Charger Module Arduino". I made several changes: * Tightened tolerance around the USB connector * Added an extra support beam near the rear of the board * Modified wire slots in the center piece on the back to start from about the height of the top of the board, instead of going all the way down to the bottom of the case * Tweaked the part coming down from the lid to fit tighter against the USB connector and come down towards the board a bit further * Adjusted screw holes to allow them to be tapped out for #6-32 screws, as I have a 6-32 tap and screws on hand. Noting my original comment, I had to print this at 102% for the board to fit correctly. I could've scaled up the source, but it's nice dealing with 1/10mm units, so I kept it as-is.