USB and SD holder mug wraparound

thingiverse

I am new to 3D printing, this is a first attempt and it's not quite right. Wasn't really digging all the square USB drive and SD card holders enough to put them on my desk. Tend to use mugs for holding tools and wanted something 'swoopy' yet functional, so here it is. ToDo * all the holes are too tight, nothing actually goes in (sticks, cards, even the mug won't seat); revise design or scale up for print (2%? 5%?) or maybe it was this new PLA+ filament? Didn't calibrate for this filament. * angle on USB sticks is a bit much; make them more upright, but so they can still be removed easily - a finger's worth of space between the mug * print warped and lifted from bed, seems to be around the holes in the first layer, maybe that pulls; the holes aren't really necessary (thought they might keep dust/crumbs from collecting), try without them So it's going to sit on my desk for a bit until more problems or fixes are found, and then perhaps a retry.