USB and Pencil Holder - Breast Cancer Foundation

thingiverse

Breast Cancer Foundation Cube CUBE: Infill 20% To achieve optimal results, select Experimental - Tree Support with infill 30% for tree support in CURA. Breast Cancer Foundation SEAL: (Option 1, Simple Color Layers) Background White: 0 to 1.0 mm Silver: 1.0 to 1.6 mm Pink: 1.6 to 3.4 mm Silver: 3.4 to 4.0 mm Observe the pictures and you will see that a lot of work has gone into Cura to create separate G-codes for each component, allowing for successful printing of the outer ring in silver without crashing with previously printed parts on my Ender 3. You can use the included G-codes to print on an Ender 3 (option 2 below) Breast Cancer Foundation SEAL: (Option 2, Mixed Color Layers) 1 - Background White: 0 to 1.0 mm 2 - Silver: 1.0 to 1.6 mm 3 - Pink: 1.6 to 3.4 mm 4 - Silver: 1.0 to 4.0 mm If you have an Ender 3, use the 4 G-codes to print option 2 of the seal. Please note that G-codes 1 thru 3 do not turn off the bed at the end of the print, preventing it from cooling down and losing bed adhesion. It will take about 20 minutes for the first print and less than 10 minutes for prints 2 and 3. And about 20 minutes for print 4. The dimensions are set to press-fit the seal into the cube. Be careful with alignment before pressing it in place, as once assembled, it cannot be separated in one piece. Please send a message or post a comment on your experience with the print. Hope you enjoy it.