Ursa King Cab Body

thingiverse

Human: Body set for King Ursa Monster truck. https://www.thingiverse.com/thing:2299884 Based on the Tamiya King Cab, this design draws inspiration from the 1988 Nissan/Datsun Pickup and Big Bear, which was based on an early 80s Datsun/Nissan pickup. The body is designed to resemble the original Ursa bear, but with a few notable differences. It will require a longer front body mount, which is included in the parts list. The rear body mount remains the same as the original Ursa bear body. To assemble this body, you'll need two additional 3mmX10 screws to secure the rollbar, which uses four bolts. Print settings: * Layer height: .2 * Infill: 50% for the main body, 25% for the roll bar About 50 grams heavier than the original Ursa Bear body, this new design is wider, longer, and taller. Parts list: * King URSA Center Body Piece (Cab center of body) * King URSA Front Body Mount (new longer front body mount for King Ursa, use original rear body mount) * King URSA Front body piece (front/nose of body) - insert a 100% layer at 115 * King URSA Optional Grill Insert Piece 1 (to help with painting the Black outs for the hood ducts) * King URSA Optional Grill Insert Piece 2 (to help with painting the Black outs for the hood ducts) * King URSA Optional Grill Insert Piece 3 (to help with painting the Black outs for the hood ducts) * King URSA Rear Body Piece (rear body bed of truck, insert a 100% fill layer at 160) * King URSA Rear Window (glue to Cab, makes the rear window of the cab) * King URSA Roll Bar (body roll bar) The Optional Grill inserts are designed to fit snugly into the hood. Apply glue and secure them in place, but be prepared to sand them for a tight fit. Print orientation: Designed to print as orientated. Recommended infill and perimeter settings: * Body: 2% infill, 1 perimeter * Rollbar: 25% infill Note: This design requires two additional 3mmX10 screws to secure the rollbar.