Upside-Down incense burner

prusaprinters

I noticed multiple “upside down” incense burners on amazon, though I was curious I wasn't willing to spend the ~20 usd they all cost.I came across this one specifically https://www.amazon.com/dp/B0B4CFSHV9/ which has a mounting spot that looked particularly easy to model, so I threw together something simple. For the curious, yes this does make sticks burn slightly faster, and with the dish I'm using most is caught but it tends to leave the whole burnt stick until the very end, which all falls and collapses over the dish I use, all to say, YMMV.The circle at the base is specifically suited for a dish I already had on hand, but I've attached the freecad project in case anyone wants to make any adjustments. I printed this in PLA, though please note you will need to have the stick hanging particularly low in the “jaws” (see picture) to avoid the flames and heat getting high enough, or they WILL melt it, even still you'll likely get some scorching, also pictured.Everything can be printed in its original file orientation, the tower halves will need supports for the square pegs at the ends, I had to trim off a bit of the supported overhangs as they still sagged a bit too much to fit.