Upgraded: Foldable Tablet / Phone Stand - No Screws

prusaprinters

Small upgrade of the original design:+ phone is held higher, so there is a place for charging cable,+ smaller phones have additional support in the middle to hold in vertical position,+ there is a longer bar at the bottom to hold phones better,+ the bar is separated at the center so that it's easy to put a charging cable.- takes a little more printing time and filament.Design is not print-in place, but in 3 parts - so absolutely easy to print.In the pack the are 2 versions:Small - with original Bottom and Arm parts and edited Hook,Big - with longer edited Hook and expanded Bottom and Arm.Small is recommended unless you need a book / notebook holder.TO DO later (if needed):Big version allows only more vertical positions. I will maybe later move arm fixing in big hook part higher, so that it allows more position adjustment and would use the shorter arm part.Infill: 30%, cubicMaterial: PLA"Hook" parts require supports with "connected to bed" (not much of them)."Bottom" parts print best with just a brim for better adhesion, so that parts do not separate during printing.I'm posting with the same license as the original design from Mike-vom-Mars that is linked.