UPDATED!!!! Follow Focus + Lens Holder Kit for 8mm rods (rail setup) 48mm wide

thingiverse

UPDATED!!!!! The rail base for "BeastGrip's Remix" edition has been perfected and added. The maximum width is achieved through carefully designed dimensions based on my trusty fablet 5.5''. Additionally, a tripod mount with an M6 screw to adapt seamlessly has been replicated!!! WARNING: It remains untested... awaiting a few rings for proper lens mounting. Lenses and DOF weight are securely held by the holder... making it impressively strong :))) This tiny setup is ideal for light cameras with 8mm 48mm spaced rods/rails, specifically designed for BeastGrip's hack edition. The lens gear was tailored to fit like a glove on Helios 44-M lenses. A holding ring for the lens boasts a diameter of 63mm (originally intended for a DOF adapter). To assemble this masterpiece, you'll need the following components beside the prints: 2 x 8mm aluminum rails 7 x 10mm M3 screws 1 x 24mm M3 screw 1 x 20mm M2 screw 3 x bearings with 3mm ID and 10mm OD 7 x thin washers (as spacers: 1x inner, 1x outer per bearing, 1x knob side) 9 x M3 nuts The setup is relatively self-explanatory, but two photos should give you a clear idea of where everything goes. If you have any questions, feel free to ask and I'll be happy to help. Print Settings: Printer: i3prusa Rafts: Doesn't Matter Supports: Doesn't Matter Resolution: 0.15 Infill: 30% Notes: As long as your printer is calibrated and prints correctly, you shouldn't encounter any issues. For the nut holes, a small knife may be needed to clean them up. I didn't experience any problems printing with PLA at 210 nozzle and 60 bed temperature.