*Updated* Ender 3 Pro Drawers

thingiverse

I've shortened the height of the drawer case so that it will clear the bed screws on my Ender 3 Pro (shown in the image where the top of the case is now flush with the left mounting rail). I've also slightly reduced to width of the components that meet with the rails, so the fit isn't so snug that it gets stuck (which was my experience). The width of the drawer cavities has not been altered however. The bottom drawer is the exact same as the original, so if you printed that already to find that the case for the drawers doesn't fit, you can still use it. The case should be printed with the openings facing upward, with no support. There are 2 top drawer files, the original and one that I have edited. - I wasn't able to easily edit the pull on the top drawer, so it is the original size with the shorter drawer walls (meaning the pull extends higher than the drawer slightly, picture attached for the comparison) - The original can still be used, BUT needs to be printed with the x-axis rescaled in your slicing program (picture attached). Make sure you ONLY edit the x-axis, and change the dimension to 16 mm.