UP3D Plus 2 Plexi Enclosure

thingiverse

Manually edited the SVG files from fumalcon to 1. Separate each part into its own file. 2. Convert units to mm. 3. Change line width to 1mm so it is visible, note that Epilog users will need to adjust back to 0.001. The scale factor is the most intimidating part as it was based on measuring my actual printer and then measuring the SVG file and scaling everything by that factor. It ended up being scaled at 1.339, which I guessed was accurate, and indeed one side panel fit perfectly when cut from cardboard. However, about that point I realized that my printer has a nozzle auto adjust connector extending the back quite a bit. Therefore, there are now "Deep" and "Shallow" versions of the left and right side panels, TopBack, and BackFloor parts. As time allows, I'll cut a set from cardboard to verify they work, then do them again in plex.