UP BOX Extruder Mounting Plate - Magnet Removal

thingiverse

Used to remove the lower magnet that can cause magnetic interference and stop the side fan from spinning when upgrading the extruder, After fitting a new extruder with dual fans and noticing that the side fan was not spinning it was bought to my attention that the lower magnet was the problem and is replaced on the UP BOX+ with a bolt in mounting plate. I have designed a plate that slots in place of the lower magnet and will allow you to mount the extruder with a bolt through the heat sink like the UP BOX+ When fitting make sure the extruder is firmly in place on the remaining two magnets before installing the bolt. You can now remove the extruder by pulling it forward out of the magnet mount, no need to unbolt everytime.