Untested Compressed air Turbine V1

thingiverse

ASSEMBLY IS STRAIGHTFORWARD AND REQUIRES ONLY A FEW BASIC TOOLS. TO BEGIN, DRILL TWO HOLES IN A 90 DEGREE ANGLE TO EACH OTHER, BUT BE CAREFUL NOT TO PENETRATE THE CENTER OF THE CASING. NEXT, INSERT THE TUBING OR PIPES AND SECURE THEM WITH SUPERGLUE. ONCE THE GLUE HAS SET, SLIDE THE 608 BALL BEARING UPON THE ROD OF THE TURBINE AND ATTACH IT IN PLACE WITH A SMALL AMOUNT OF SUPERGLUE. WHEN SECURING THE BEARINGS, BE CAREFUL NOT TO OVERSPLASH THE OUTER WALL. FOLLOWING THIS, INSERT THE BEARING AND ROD INTO THE CASING AND GLUE THE OUTER WALL OF THE BEARING TO THE HOLE. FINALLY, PLACE THE LID ON TOP AND BLOW AIR THROUGH ONE TUBE. IF THE MODEL SPINS PROPERLY, YOU CAN PROCEED WITH ATTACHING THE GEAR TO THE ROD USING SUPERGLUE. FOR MAINTENANCE OR SMALL ADJUSTMENTS, THE LID REMAINS UNGLUED.