University of Washington Huskies Poker Card Capper

thingiverse

This is a Weighted Poker Card Capper. It's designed to sit on your hole cards during a hand, ensuring they don't get accidentally folded. The base has the same diameter as a standard poker chip (39mm), so it stacks perfectly with your chips when not in use. The design features the University of Washington Huskies "W" Logo. If you like this, be sure to check out my collection of card capper designs on Thingiverse. To print: 1. Print two Infill_W parts. 2. Print one each of the other parts. 3. Print the Husky_W_Logo upside down, so it looks like an "M". No support is needed. 4. I printed the holder and base with line support material spaced at 4.5mm. Assembly: 1. Place four nickels inside the holder before snapping it into the base. 2. Snap the base over the top of the holder. 3. Press the two Infill_W parts into either side of the Husky_W_Logo, using a few drops of glue to secure them. 4. Press the assembled W logo onto the two tabs on the top of the base. Enjoy your printed capper! If you print one, please share a picture.