Universal Horizontal Spool Holder Remix for 8x22x7 608 Bearings

thingiverse

The original thing (https://www.thingiverse.com/thing:4360271) didn't fit the bearings that I had so I remixed it to properly fit the bearings that I had on hand. The bearings this unit was designed around are https://smile.amazon.com/gp/product/B07JB2Y4H3/ref=ppx_yo_dt_b_asin_title_o05_s00?ie=UTF8&psc=1 Fusion 360 File Included. There is a version with both a fixed and spinning center post. The base plate and bearing bushings are the same for both parts. You will need 3 bearings for the fixed post version and 4 for the spinning post version. The base plate is for attaching to a drybox for printing, it is by no means required for this thing. It is designed to use 4 M3 bolts and nuts Regardless of which version you are printing you will need: 3 x M5 x 20 socket head screws (head can be no larger than 8mm) (To mount each bearing) 3 x M5 hex nuts no deeper than 3.5mm 3 x Bearing (4 if using the spinning post) If printing the spinning center post you will need to print: 1 x Base V4 1 x CenterPost V3 3 x BearingBushing V2 1 x BasePlate (if desired) Note: The center post bearing does not require a bushing. If printing the Fixed Post you will need to print: 1 x BaseMinusCenterBearing 3 x BearingBushing V2 1 x BasePlate (if desired) The only file that requires any support is the Center Post, I tried printing it both on its side and standing up. The way that seemed to work the best was with full support underneath with the post standing up. They're a little annoying to remove, but with patience they weren't that bad.