Universal filament spool winder with crank

prusaprinters

<p>This spool winder works with any(?) 1kg spool with an inner diameter betweeen 40 and 60mm.</p><p>This model is a Remix and contains all parts needed from the original (See Luke's 3D Spool Winder v3).</p><p>I made this for my wife so she can store her clothsline in a proper way.</p><p>&nbsp;</p><h4>Parts to print</h4><p><strong>Basic frame:</strong></p><ul><li>2x bearing</li><li>4x side</li><li>2x bottom</li><li>3x rod</li><li>6x nut</li></ul><p><strong>Universal Axis:</strong></p><ul><li>2x AxisCenterRing</li><li>1x Axis (Print at 100% infill as this sees a lot of force)</li><li>3x AxisNut</li><li>2x shaft-washer (maybe more, depending on your spool)</li></ul><p><strong>Handle:</strong></p><ul><li>1x SpoolHolderHandle</li><li>1x SpoolWinder Handle Nut</li><li>1x SpoolWinder Handle Grip</li></ul><p><strong>Assembly instructions:</strong></p><ul><li>The basic frame should be easy to figure out (sides and buttom connected with the rods and secured with the nuts). Luke3d has a youtube vid on his version for the cable winder.</li><li>Handle is also easy, plug the grip on the axis and secure it using the nut</li><li>Axis: For this i have added a Picture (true piece of Art!). I hope you can make some sense of it.<ul><li>First install the bearings to the sides with the spacer to the outer sides</li><li>Insert the axis into the handle</li><li>Insert the axis with the handle into the bearing (the bearings spacer is outside where the handle is)</li><li>Add a washer (red)</li><li>Add a center ring</li><li>Add your spool</li><li>Add another center ring</li><li>Add a Axisnut and scew it tight so the spool sits secure</li><li>Add another axisnut loosely</li><li>Add a washer</li><li>Insert everything into the 3nd bearing</li><li>Now add the last nut from the outside and use the two nuts to secure the bearing between them, so it can rotate freely.</li></ul></li><li>If the handle is striking against the body while winding, use an hotgun or hair dryer to heat it up a bit and sliglty bend it outwards. Careful, PLA gets soft very quick.</li></ul><p>Have fun &amp; Leave a make!</p>