Universal Case (enclousure) Corner for 6mm wood. Build your own printer case / Cantoneira universal para chapas de 6mm. Construa seu próprio case

thingiverse

These are universal corners for assembling a case for your printer without spending too much. You can assemble any size of case as long as you use a 6mm wood plate, which can be MDF or MDP. For Anet A8 Plus, the plate dimensions are: 2x 60 x 60 cm (front and back) 2x 60 x 70 cm (sides) 2x 61.2 x 70cm (floor and cover) For Ender 3 and Anet A8, the measures are: 2x 51 x 50 cm (front and back) 2x 51 x 61 cm (sides) 2x 51.2 x 61cm (floor and cover) In my case, I opened windows of 40x40 and installed acrylic for viewing and easy maintenance from either side. There are 5 files explained below: * Corner Type 1 Front-Bottom: This corner always fits on three sides. Use it on two sides of the cover (front or back) and/or four sides at the bottom if you want to use a wooden board as a floor. * Drawer-Style Back Corners: These corners are for both sides of the cover, serving as guides for inserting and removing the cover for easier printer maintenance. * Optional Bottom Corners: Use these simple corners for the four corners under the cabinet if it doesn't have a floor. Print 4 pieces this way. This setup will leave gaps on the sides and allow air passage. * Front Complement and Side Complement: These parts close the gap between corners. Measure matches Anet A8 Plus case dimensions; increase or decrease as needed. Don't use these, as your case can get too hot. My recommendation for a printer supported on the floor or table: To Print: 2x Corner Type 1 Front-Bottom -> Front of cover 2x Drawer-Style Back Corners -> Back of cover 4x Optional Bottom Corners -> 4 Floor Corners This configuration leaves an air passage and prevents engine overheating, ABS warping.