Under-Table Hooks for Rubbermaid Shelf

myminifactory

I was plagued by a messy cable management situation in my office. I desperately needed a solution to keep all these cables and components in order. Luckily, I had a Rubbermaid HomeFree Series shelf collecting dust, so I created these hooks to attach it under my desk. Now, everything is neatly organized out of the way on the shelf! I 3D-printed this design using black PLA at a layer height of 0.35mm and 60% infill. So far, it's holding up well. To achieve the best results, I recommend printing it flat on its side with the hooks curving upwards off the bed. A small amount of support for the hooks is also sufficient. However, avoid printing it standing upright as this will compromise the structural integrity of the design.