Under-desk Headphone Holder for IKEA Adils and Linnom

prusaprinters

Do you own IKEA but wish you had a better way of holding your headphones? Well have I got the solution for you. Introducing: this model.Printing Instructions:If I'm being honest, I probably could've designed this to be easier to print. However, since the bottom side of the holder will never really be seen, printing in the same orientation as the second photo (the 3D render) with supports will yield good results (e.g. hook on bottom, screw-in plate on top.)Installation Instructions: Simply unscrew three of the screws holding in the leg, place the headphone holder on top of it, arrange the holder such that the screw holes line up again, then re-screw them back in.  Side Note: After creating/printing this model I realized that somebody already created their own take on a headphone hanger for this specific desk leg. I personally like how my design hangs a touch lower, but take a look at the other one too! It is really well designed! Let me know if you have any suggestions for changes!Simon