Under Cabinet Drawer

prusaprinters

The concept behind this design is to have simple practicality, where you can pull this drawer and left it hanging for you and someone else quickly grab it. Perhaps throwing a party, your visitor will be able to see where the cutlery is at without having to take out the whole cutlery to serve them. Or perhaps for your tools, or some spare parts that will go down whenever this drawer has been pulled with the power of the gravity.Choose any angle you would like from 15 to 75 degrees after it has been pulled out.PrintingThe tray may be too large even for original prusa i3. simply trim the dovetail end a little bit to make it fit. Mountings must have supports for the overhang slots.At least 3 perimeters/walls are recommended for the Mounting and Angle Limiter, add more for heavier stuffs.AssemblyUse the Drilling Jig to drill the hole for best alignment.Put on angle limiter to the tray.Put on mountings on the tray.Pull the tray all the way out.Screw the mountings to your cabinet.Put the tray back inside.UpdateAdded smaller variants to fit printers less than 200mm sizes (felt bad and hanging without catering smaller sized printers too)