Uncle Bens Ender 3 & Ender 3 Pro Fang for 40mm Fans with BLTouch and Neopixel support

thingiverse

<b>Introduction:</b> Combining jckz82's fang and StevenMLawson's BLTouch mount, this remix adds an optional LED strip mount. The fang remains securely attached to the hotend by two screws that pass through it. Refer to the pictures for the correct printing orientation. <b>Mounting Requirements:</b> - Two M3x20 screws are necessary for securing the hotend (M3x18 will also suffice) - Eight M3x20 screws, or their equivalents, are required for mounting the fans; 20mm is a suitable length for 10mm thick fans, but adjust according to your fan's specifications - super/hot glue can be used as an alternative - An optional LED strip: 10mm in width and not exceeding 100mm in length <b>Instructions:</b> - Print at 0.2 resolution - Use supports that 'touch the build plate' for both the fanduct and led mount during printing - Refer to the provided screenshot for correct printing orientation - Ensure the hotend fan is mounted correctly: pass the screw through the LED mount, then the fan, followed by the fanduct - BLTouch offsets in mm: X -48.0, Y -28.0, Z -1.15