UMX Timber Wall Mount

thingiverse

This is a mount for the rear wheel of the Horizon Hobby UMX Timber. I created it so that the wheel stays secure while allowing the wire to slide through freely. Adding some double-sided sticky tape, which I used double-sided sticky foam from Walmart in the pictures, holds perfectly and doesn't damage your wall. I printed mine at 100% infill since the walls are only 2mm thick; even with a high infill rate, the print time was just over an hour at 15 grams of material. A 20-30% infill should also work well due to the UMX Timber's very light weight. This design requires support, and I printed it as shown in the images with the part that attaches to the wall flat on the bed.