Ultimaker S5 Risers

thingiverse

My Ultimaker S5 is on a workstation top that has shelves at the back. The height of the bottom shelf interferes with the spool mount for the RFID chip reader. It is a fixed in place shelf. This has caused me to have to have it at the front edge of the surface. These risers go under each corner of the printer and raise it about 1/5 inches to provide clearance for the spool to be above the bottom shelf. There are two STLs attached, one is for Front Left/Back Right. The other is for Front Right/Back Left. You will see why there are two and not just one when you look at the files. The sides of the printer extend past the front and rear pieces. Print two of each part.