Ultimaker Dual Print Rubber PLA foot

youmagine

Check Main Information first. This setup is for the front left and back right feet only; mirror it in the X plane to get the other two. Run a test now, despite a blocked nozzle midway through printing, I've managed to fit what was printed and it fits perfectly. I achieved good results with the following settings: 0.2 layer height, 50mm/s, ooze shield and wipe and prime tower enabled, retraction ON. Fan set to 0 min, 100 max, turning on at 5mm. For Flex PLA, I used 250 degrees, no fan for this lower part. Regular PLA was printed at 220 degrees, with the fan starting at 5mm Z. No oil is needed for Flex PLA in my experience; it feeds well at this temperature. As seen from photos of the ones I've printed, I'm still having trouble with oozing. If anyone has suggestions on how to improve this issue, please share them in the comments below. After just installing these parts, I can confirm they fit like a custom-made glove.