ULA Support Bracket.04

grabcad

The material used is Ultem 9085, weighing 0.064 lb with a volume of 1.328 in³, resulting in a density of 0.048 lb/in³ or 1.34 g/cm³. The support bracket, designed for a load capacity of 600 lbf, has a maximum stress of 3394 psi and a factor of safety (FOS) of 1.33. Composed of three parts - the bridge bracket and right/left mounts, this design eliminates support material in holes that face the Z direction in a 3D Printer. No support is required on any surface, including the holes. The left and right mounts fit into the support bracket via snap-fit mechanism. Assumptions include fastening the bracket to the vehicle interface with bolts having heads diameter of approximately 0.438". As assembly analysis capabilities are not available, individual parts (bridge bracket and right mount) are shown in the design.