ULA ORGANIC BRACKET V_02

grabcad

ULA ORGANIC BRACKET VERSION 2Design Inspiration: Tree, Bone, Beam, Bridge, TrussThis design is specifically optimized for 3D printing (eliminating overhang features and elements with angles greater than 45 degrees to minimize print support material).Volume: 2.053 in^3Mass: 0.099 lbManufactured via 3D PrintingFE Analysis:Maximum Design Stress (Von Mises): 3,897 psiApplied Force: 600 lbf total (across two faces)Assumed Constraints: Four bolt hole locations* Optimization Notes and Focus: Due to the low material yield strength, it is crucial to focus on the middle bridge area (between the right and left bolt fixtures). It's tempting to make that section as thin as possible, but if force isn't directly applied there, it will concentrate on the vertical fixtures.To maintain maximum stress while keeping that area thin, it's possible to do so, considering there is no direct force. However, considering the low yield strength of the material, this area requires closer examination and alternative force directions for studying its behavior.In my design, I achieved rigid construction in that specific area by employing a truss-like structure.Best regards and good luck to all participants,Ardhia Pramesti