Ukulele Fully printable

thingiverse

Sopranissimo Ukulele fully 3d printable Scale length: 26 cm Radiused fingerboard No glue and no supports needed when printing body in one piece. This ukulele simply slides together and can easily be taken apart for traveling. The top is braced to prevent sagging. The Tuners are friction pegs and are easy to use. A two piece body file is included if the body is too big for your 3D printer or for when print times are too long. The two piece body also yields better results when the overhangs are not as good as expected. Print instructions: - Neck Layer height: 0,16 mm Wall line count: 4 Use 30% infill In Ultimaker cura, turn off adaptive layers - Body Can be printed in one piece or in two separate pieces (requires glueing) When printing in two parts the bridge needs supports, use support block on the inside of the body. Layer height: 0,2 mm - Pegs Layer height: 0,16 mm Use 100% infill - Nut Use 100% infill so that the nut can be filed down for adjusting string height Assembly instructions - For 2 piece bodies Glue the body together using a strong glue, I use Revell Contacta for this. - For 1 piece bodies and after glueing the 1 piece body stick the tuning pegs in the tuning peg holes and slide the neck in the neck pocket. Mount the strings to the body and the tuning pegs and bring them up to a slight tension Insert the nut and adjust the string indentations by filing them to the size of your strings. Adjust String height by filing the bottom of the nut to the correct height. Tune up your ukulele en get to the playing part!