Ugly Tyro69 TPU

thingiverse

This is for TPU only. I was fed up with how uneven the spacers that came with it looked. 3mm spacer goes between the frame and the ESC unit. 4mm spacer goes between the ESC unit and the Flight Controller board. 5mm spacer goes between the Flight controller board and the canopy. For best results, I printed one spacer at a time. When installing the canopy. Hang the vtx/camera and rx off the back first. Put the VTX antenna through the loop. Then add the camera. I secure my RX with shrink wrap on top of the VTX. You could use double-sided tape to hold the VTX in place, then attach the RX on top of that. Feed the RX wires through the holes and then apply shrink wrap. The camera is positioned at a 30-degree angle.