UBQ180 Rugged-Style Prop Guard

thingiverse

A retooled version of the Hovership Rugged-Style Prop Guards is available. Note: These will fit the slots in the UBQ180 motor mounts, but only if they are used with slits instead of holes (I'll redo this later when I have time).\nThe set includes four pieces, each compatible with a 2.5-inch propeller.\nThe arc angle has been reduced to approximately 180 degrees,\nThese prop guards can be resized as needed.\nPrint Settings:\nPrinter: Wanhao i3 equipped with AVN Swiss All Metal Hotend\n Rafts: No rafts were used in this print.\nSupports: No supports are required for these small parts.\nResolution: The default resolution of 0.2 mm was used for this print.\nInfill: Since these parts are small, the infill can range from 20% to 100%. Anything goes. Notes: These prop guards were printed in PETG at a temperature of 240°C using a heated bed and sliced with Simplify3D. They are very flexible and resistant to impacts from my furniture.