UBQ Lowrider remix

thingiverse

This is my take on the UBQ lowrider, reimagined with a focus on better ventilation for the vtx, enhanced protection for the camera, and several other mods that improve both design and usability of the UBQ. The UBQ excels in fast racing and agile flight. This frame will accommodate motors from 1804 up to 2206, KV 2300 being a good starting point. I'm running 20amp escs paired with 2206 motors and 4045 tri props featuring bullnose designs. The flight controller is a Naze 32 rev 6b with cleanflight on board. The camera is a high-resolution 600tvl cmos sensor, accompanied by a 25mw vtx. This is a reworked version of item http://www.thingiverse.com/thing:919482, created with kind permission from the original author. Video footage of my UBQ remix in flight can be seen here https://youtu.be/hSpMXi4ljAE and also here https://youtu.be/_camhAVpWMg, showcasing its versatility even indoors. Print Settings Printer Brand: MakerBot Printer: MakerBot Replicator 2X Rafts: No Supports: Yes Resolution: 0.2mm Infill: 100% Notes: I printed in PLA at a temperature of 230c on the print bed and 65c on Kapton tape. After printing is complete, allow about 5 minutes for cooling before removing from the print bed to permit full curing of lower layers.